[G1-Oett] Bolts for cylinderhead (culasse)

[JRF]

Hi. Do you guys know if it's possible to get the bolts that tighten the cylinderhead to the engineblock for the Oettinger 16S? If so, where can I buy them? They're out of stock with Oettinger...

[Vanvan]

Hello. I don't know where you can buy the blots, but look at this:
http://www.passiongolfgti.com/article.p ... rticle=433

It should be a good walk-over
regards

[romaingirardlamamy]

hi JRF
yes like vanvan said there is a nice article to make oettinger head bolt out of standard 1.6 GTI bolts ( they just need to be machined )
be also aware that ARP studs will fit without problems
if you have any trouble with the translation please do let me know
i ll help you out

[JRF]

Thanks a lot guys. I sincerely appreciate kindness and help in my quest to get my Oettinger in mint condition. I studied French language for three years while in college but I must admit that I struggle a bit when it comes to technical terms. Anyways, looks like I will order a regular EG cylinder head gasket and make it fit the Oettinger and use remachined EG bolts. Thanks again guys!